Products > MTS Models > Personal Use | Clinical Use | Medical Use

MTS-Roller™ - Clinical Use

Introduction | Directions for use


THE CLINICAL MTS-ROLLER PROCEDURES:


  • Step 1) Cleansing
    Clean hair with shampoo, rinse thoroughly and towel dry.
    After gently cleansing and drying of the targeted scalp area, HR Matrix is applied in a thin layer.


  • Step 2) Treatment Roller
    The following MTS-Roller treatment enhances the agent into the deeper skin layers. A regular and soft “rolling” with minimal pressure is sufficient. (High pressure does not infiltrate more substances into the skin!).

    It is recommended to move the MTS-Roller only in one direction, from the crown to the front and/or sides. This procedure avoids that longer hair get tangled in the roller. Natural hairs are very thin (0.05 to 0.06 mm). So it does not matter if the needles roll over several hairs at the same time.



  • Step 3) Apply HR Matrix
    Apply to fingertips, then directly onto target area of scalp, 1-2 hours before bedtime to provide sufficient time for scalp to absorb the product. Rub scalp with fingertips vigorously for 2-3 minutes. Wash hands directly following application. Allow product to remain on scalp for at least four hours before washing hair. HR Matrix should be used on a daily basis.


  • Step 4) Clean Roller
    Clean roller per instructions and return roller to protective case.

We recommend that you use the MTS-Roller at bedtime every other day until your skin becomes accustomed to the roller. After the second or third week you may roll daily if you think it is necessary.


WARNING: Do not use the MTS-Rroller vigorously or more than once daily unless prescribed by a professional skin care specialist.


Cleaning MTS Roller™

PERSONAL USE MODELS CR5: You may use denture tablets (in water) to clean the MTS Roller™. Denture tables are enzyme cleansers and enzymes take off fat as well as reduce bacteria. While not as effective, you may also use alcohol (isopropyl). Consult a pharmacist for the best advice for a sterilization solution. Open the cleaning tray and place the white cleaning pad in the larger half of the tray. Fill the cleaning tray with sterilization solution and roll the roller into the pad with medium pressure. Leave the MTS Roller in the cleaning solution for about 15 to 30 minutes – ensure that the roller drum is constantly wet with the cleaning solution. After cleaning, rinse with tap water and return the roller to the protective case and allow it to air dry. Replace the case lid until the next use.


Storing MTS Roller™

The MTS Roller is delivered in a protective case and sealed in a sterilized pouch. Tear open the pouch at the notch and discard. After each use (and cleaning) return the MTS Roller back to the protective case.
NOTE: Always treat the MTS Roller gently and avoid any contact with hard objects or surfaces. Replace all rollers that have been dropped. Keep rollers out of reach of children.


Important Reminders

Do not use MTS Roller™ on irritated skin, infected skin, fungal skin infections, active acne, rosacea, eczema, psoriasis, severe solar keratosis, raised moles and/or warts, and/or any open wounds or sores. Patients who are not sure about their skin condition should consult a dermatologist before using the MTS Roller™.

Clinical tests have not shown any side effects from using MTS Roller™ when used as directed under the advice or supervision of a trained skin care professional. Use serums, creams and/or any other cosmeceutical or herbal topical only with the advice or supervision of a trained skin care professional.

MTS Roller™ should be stored in the supplied protective plastic box for maximum hygiene and safety after use. The instrument must be kept out of reach of children.


Using MTS Roller™ with cosmetics/cosmeceuticals.

MTS Roller™ is a skin care tool that partially and temporarily pierces the topmost protective layer of skin. We advise that patients/clients apply serums, creams or other ‘topicals’ only under the direction of a qualified skin care professional. The reason is simple. Most skin care topicals (cosmetics, cosmeceuticals) are designed to be harmless while they are on the surface of the skin, however the skin may react differently when such products are infiltrated through the epidermal barrier, such as what occurs with MTS Roller™. We recommend that patients/clients speak to a qualified skin care professional if there is any doubt about the ingredients in any products and whether they are suitable for infiltration.


Sensitivity and Redness when using MTS Roller™

Patients will experience mild sensitivity and redness after treatment; signs that the fine micro points have penetrated the epidermis. The perforated stratum corneum will close within minutes and the sensitivity should abate quickly. The general redness will disappear within one or two hours of treatment. Intensity and duration of any discomfort may increase if the MTS Roller is used in combination with skin care products (cosmetics, cosmeceuticals).


GUARANTEE: 100% Contaminant-Free
MTS Rollers are sterilized with gamma radiation and sealed in a hermetic pouch and are guaranteed to be 100% contaminant-free upon delivery.



Next: Products | MTS Model | Medical Use | Introduction -


Copyright notice © 2015, Clinical Resolution Laboratory, Inc.
Your use of this Site constitutes your agreement to comply with the following terms and conditions (the "Agreement")
Microneedle Therapy System™ and MTS Roller™ are trademarks of Clinical Resolution Laboratory, Inc.